Inversion iterative correction method for estimating shear strength of rock and soil mass in slope engineering

Authors

Wei JIANG, State Key Laboratory of Simulation and Regulation of Water Cycle in River Basin, China Institute of Water Resources and Hydropower Research, Beijing 100038, China
Ye OUYANG, Key Laboratory of Geological Hazards on Three Gorges Reservoir Area of Ministry of Education, China Three Gorges University, Yichang, Hubei 443002, China
Jin-zhou YAN, Key Laboratory of Geological Hazards on Three Gorges Reservoir Area of Ministry of Education, China Three Gorges University, Yichang, Hubei 443002, China
Zhi-jian WANG, Key Laboratory of Geological Hazards on Three Gorges Reservoir Area of Ministry of Education, China Three Gorges University, Yichang, Hubei 443002, China
Li-peng LIU, State Key Laboratory of Simulation and Regulation of Water Cycle in River Basin, China Institute of Water Resources and Hydropower Research, Beijing 100038, China

Abstract

For the slopes that have failed or deformed significantly, the shear strength of rock and soil mass is frequently inversely estimated based on a factor of safety assumed. For the slope with a sliding surface passing through multi-layer rock and soil mass, it is unreasonable to achieve this goal by blind trial. To solve this issue, back propagation (BP) neural network is constructed using shear strength of multi-layer rock and soil mass as the input, and the factor of safety of slope, the entrance and exit positions of the sliding surface obtained by Geoslope as the outputs. Then, based on the assumed factor of safety and the entrance and exit positions measured in site, the shear strength is acquired by carrying out the “reverse back analysis–error check–sample correction” procedure repeatedly. The result of a case study verifies that the shear strength obtained by this method is reasonable and can be used as a reference when designing reinforcement measures for small-scale slopes. BP neural network usually considers the known information as the input, and the information to be determined as the output, which will induce a mathematical underdetermined problem when solving this issue. The proposed method avoids this demerit successfully, and has a lower requirement on the number of samples in the library and a higher precision compared to the classical BP neural network.

Graphic Abstract

Recommended Citation

JIANG, Wei; OUYANG, Ye; YAN, Jin-zhou; WANG, Zhi-jian; and LIU, Li-peng (2022) "Inversion iterative correction method for estimating shear strength of rock and soil mass in slope engineering," Rock and Soil Mechanics: Vol. 43: Iss. 8, Article 7.
DOI: 10.16285/j.rsm.2021.6578
Available at: https://rocksoilmech.researchcommons.org/journal/vol43/iss8/7